(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Interchange the rear airbag sensor RH with LH and connect the connectors to them.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG), and wait for at least 60 seconds.
(f) Clear the DTCs stored in the the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(g) Turn the engine switch off.
(h) Turn the engine switch on (IG), and wait for at least 60 seconds.
(i) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
Result:
Text in Illustration
HINT
Codes other than DTC B1632 and B1637 may be output at this time, but they are not related to this check.
C -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
B -- REPLACE REAR AIRBAG SENSOR LH
A -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and Safety
Systems/Air Bag Control Module/Service and Repair/Removal
Part 1
SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM:
B1627/82,B1628/82,B1637/82,B1638/82,B1647/82,B1648/82,B1697/82,B1698/82: Lost communication with Side Airbag Sensor LH
B1698/82 - Door Side Airbag Sensor LH Initialization Incomplete
DESCRIPTION
The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH, rear seat side airbag assembly LH and
curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, side airbag sensor LH (for rear side), rear airbag sensor LH
and side airbag sensor LH (for front side).
The side airbag sensor LH (for rear side), rear airbag sensor LH and side airbag sensor LH (for front side) detect impacts to the vehicle and send
signals to the center airbag sensor assembly to determine if the airbag should be deployed.
These DTCs are recorded when a malfunction is detected for the side collision sensor LH circuit (to determine deployment of the front seat side
airbag assembly LH, rear seat side airbag assembly LH and curtain shield airbag assembly LH).
No comments:
Post a Comment