Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN NO. 2 BUS BRANCH WIRE OR CONNECTOR (CAN NO. 4 J/C - CLEARANCE
WARNING ECU)
OK -- Continue to next step.
18. CHECK FOR SHORT IN CAN NO. 2 BUS WIRE (CAN NO. 4 J/C)
(a) Reconnect the CAN No. 4 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NOTICE:
The resistance must be measured after the main wire connected ECU and junction connector are reconnected.
NG -- REPLACE CAN NO. 4 JUNCTION CONNECTOR
OK -- Continue to next step.
19. CHECK FOR SHORT IN CAN NO. 2 BUS WIRE (ECUS)
(a) Connect the probes of an ohmmeter to terminals 26 (CA2H) and 25 (CA2L) of the power management control ECU.
No comments:
Post a Comment