WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information See: Brakes and
Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning.
HINT
When DTC C1241 and/or C1417 is output together with DTC C0278 and/or C0279, inspect and repair the trouble areas indicated
by DTC C1241 and/or C1417 first See: C1241, or See: C1417).
PROCEDURE
1. INSPECT ABS NO.2 FUSE
(a) Remove the ABS NO. 2 fuse from the engine room relay block.
(b) Check if the fusible link is melted.
OK:
The fusible link is not melted.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment