OK -- REPLACE CAN NO. 6 JUNCTION CONNECTOR
5. CHECK FOR OPEN IN CAN BUS MAIN WIRE (MAIN BODY ECU)
(a) Reconnect the CAN No. 6 junction connectors.
(b) Disconnect the main body ECU connector.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN MS BUS MAIN WIRE OR CONNECTOR (CAN NO. 6 J/C - MAIN BODY ECU)
OK -- REPLACE MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) See: Power and Ground Distribution/Power
Distribution Module/Service and Repair/Removal
6. CHECK FOR SHORT IN CAN MS BUS WIRES (TILT AND TELESCOPIC ECU)
(a) Disconnect the tilt and telescopic ECU connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CHECK FOR SHORT IN CAN MS BUS WIRES (CAN NO. 6 J/C - TILT AND TELESCOPIC ECU)
OK -- REPLACE MULTIPLEX TILT AND TELESCOPIC ECU
7. CHECK FOR SHORT IN CAN MS BUS WIRES (CAN NO. 6 J/C - TILT AND TELESCOPIC ECU)
(a) Reconnect the tilt and telescopic ECU connector.
No comments:
Post a Comment