WIRING DIAGRAM
INSPECTION PROCEDURE
This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability
control system first.
PROCEDURE
1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
(e) Check for DTCs.
Result:
B -- GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) See: Diagnostic Trouble Code Descriptions/Vehicle
Stability Control System
A -- Continue to next step.
2. REPLACE COMBINATION METER ASSEMBLY
(a) Replace the combination meter assembly See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service
and Repair/Removal and Replacement/Combination Meter/Components.
NEXT -- Continue to next step.
No comments:
Post a Comment