INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information See: Brakes and
Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning.
PROCEDURE
1. CHECK STOP LIGHT OPERATION
(a) Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
OK:
NG -- INSPECT STOP FUSE
OK -- Continue to next step.
2. READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Select the Data List on the Techstream See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Data List / Active Test.
ABS/VSC/TRAC
(d) Check that the stop light switch display observed on the Techstream changes according to brake pedal operation.
OK:
The Techstream displays ON or OFF according to brake pedal operation.
No comments:
Post a Comment