Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (ECM MAIN WIRE)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Disconnect the ECM connector.
No comments:
Post a Comment