* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1825, B1826, B1827, B1828 or 56 is not output.
HINT
Codes other than DTC B1825, B1826, B1827, B1828 and 56 may be output at this time, but they are not related to this check.
Text in Illustration
NG -- CHECK NO. 2 FLOOR WIRE (SIDE SQUIB LH CIRCUIT)
OK -- REPLACE FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
1. CHECK NO. 2 FLOOR WIRE (SIDE SQUIB LH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect SST from connector C.
(d) Disconnect the No. 2 floor wire from the center airbag sensor assembly.
(e) Check for a short to B+ in the circuit.
(1) Connect the cable to the negative (-) battery terminal.
(2) Turn the engine switch on (IG).
(3) Measure the voltage according to the value(s) in the table below.
No comments:
Post a Comment