HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
MS Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN MS Bus
Wire inspection.
NG -- CHECK FOR SHORT IN CAN MS BUS WIRES
OK -- Continue to next step.
15. CHECK FOR CAN MS BUS BRANCH WIRE
(a) Reconnect the CAN No. 6 junction connectors.
(b) Connect the probes of an ohmmeter to terminals CANH or CANL and GND or +B of the tilt and telescopic ECU.
Text in Illustration
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
MS Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN MS Bus
Wire inspection.
(c) While observing the resistance value shown on the tester, disconnect branch wire connector (except F74 and F78) from the CAN No. 6
junction connector until the resistance becomes normal (6 kOhms or higher (for +B short) or 200 Ohms or higher (for ground short)).
No comments:
Post a Comment