Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
MS Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN MS Bus
Wire inspection.
NG -- REPAIR OR REPLACE CAN MS BUS MAIN WIRE OR CONNECTOR (CAN NO. 6 J/C - TILT AND TELESCOPIC
ECU)
OK -- Continue to next step.
14. CHECK FOR SHORT IN CAN MS BUS WIRES (CAN NO. 6 J/C - MAIN BODY ECU)
(a) Disconnect the CAN No. 6 junction connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment