Text in Illustration
NG -- CHECK NO. 2 FLOOR WIRE (SHORT TO B+)
OK -- Continue to next step.
5. CHECK SEAT POSITION AIRBAG SENSOR CIRCUIT (SHORT TO GROUND)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- CHECK NO. 2 FLOOR WIRE (SHORT TO GROUND)
OK -- Continue to next step.
6. CHECK SEAT POSITION AIRBAG SENSOR
(a) Connect the connectors to the center airbag sensor assembly and seat position airbag sensor.
(b) Connect the cable to the negative (-) battery terminal.
No comments:
Post a Comment