Text in Illustration
(d) w/o Navigation System:
(1) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- CHECK INSTRUMENT PANEL WIRE (SHORT TO B+)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and
Safety Systems/Air Bag Control Module/Service and Repair/Removal
9. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the center airbag sensor assembly and radio receiver assembly*1 or accessory
meter assembly*2. Also check that the connectors that link the instrument panel wire and No. 2 instrument panel wire are properly
connected.
*1: w/ Navigation System
*2: w/o Navigation System
No comments:
Post a Comment