HINT
Codes other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.
C -- REPLACE FRONT AIRBAG SENSOR RH
B -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and Safety
Systems/Air Bag Control Module/Service and Repair/Removal
A -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1603/83,B1612/83,B1613/83: Front Satellite Sensor Bus RH
Initialization Incomplete
B1603/83 - Front Satellite Sensor Bus RH Initialization Incomplete
B1612/83 - Lost Communication with Front Airbag Sensor RH
B1613/83 - Front Airbag Sensor RH Initialization Incomplete
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH.
The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be
deployed.
These DTCs are recorded when a malfunction is detected in the front airbag sensor RH circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
No comments:
Post a Comment