(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CHECK FOR SHORT IN CAN MS BUS WIRES (MAIN BODY ECU)
OK -- Continue to next step.
9. CHECK FOR CAN MS BUS BRANCH WIRE
(a) Reconnect the CAN No. 6 junction connectors.
(b) Connect the probes of an ohmmeter to terminals CANH and CANL of the tilt and telescopic ECU.
Text in Illustration
(c) While observing the resistance value shown on the tester, disconnect branch wire connector (except F74 and F78) from the CAN No. 6
junction connector until the resistance becomes normal (between 54 and 69 Ohms).
Text in Illustration
HINT
* The connectors connected to the CAN junction connector can be distinguished by the colors of the bus wire.
* Reconnecting the connectors to non-specified positions on the CAN junction connector does not affect system operation.
No comments:
Post a Comment