NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE OUTER MIRROR CONTROL ECU LH See: Body and Frame/Mirrors/Power Mirror Control Module/Service
and Repair/Removal
From 08/2009
NETWORKING: CAN COMMUNICATION SYSTEM: U0200: Lost Communication with "Door Control Module B"
U0200 - Lost Communication with "Door Control Module B"
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch
wires.
* Turn the engine switch off before inspecting CAN bus wires for a ground short.
* After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not
operating.
* Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other
No comments:
Post a Comment