HINT
* *1: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
* *2: If the power connector is disconnected after the engine starts, this DTC is stored after 180 seconds.
* *3: If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the
device.
* *4: This DTC may be stored if the engine is started and the engine switch start again.
NOTICE:
* Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check
for DTCs and troubleshoot according to the output DTCs.
* The radio receiver assembly is the master unit.
* Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
NOTICE:
Be sure to read Description before performing the following procedure.
PROCEDURE
1. CHECK "RADIO RECEIVER COMMUNICATION ERROR" IN FLOW CHART
HINT
Refer to Radio Receiver Communication Error See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Testing and Inspection/Symptom Related Diagnostic Procedures/Audio and Visual System (w/o Navigation System)/Radio
Receiver Communication Error.
NEXT -- END
DTC 01-E0
AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (w/o Navigation System): 01-E0,01-E3,01-E4: Registration Complete Indication Error
01-E4 - Multiple Frame Incomplete
DESCRIPTION
HINT
Even if no fault is present, these DTCs may be stored depending on the battery condition or engine start voltage.
INSPECTION PROCEDURE
HINT
After the inspection is completed, clear the DTCs. These DTCs do not indicate a malfunction.
No comments:
Post a Comment