Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If the front speed sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.
NG -- CLEAN OR REPLACE FRONT SPEED SENSOR ROTOR
OK -- Continue to next step.
9. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FRONT SPEED SENSOR)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(b) Disconnect the skid control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for RH
for LH
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
10. INSPECT SKID CONTROL ECU (SENSOR INPUT)
No comments:
Post a Comment