(b) Check for DTCs See: Steering and Suspension/Steering/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
OK:
DTC is not output.
NG -- GO TO CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/How to Proceed With
Troubleshooting
OK -- CHECK INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
Up to 08/2009
NETWORKING: CAN COMMUNICATION SYSTEM: U110B,U1110: Lost Communication with Parking Assist Control Module "B"
U1110 - Lost Communication with Clearance Sonar Module
DESCRIPTION
HINT
The parking assist ECU includes the clearance sonar module (w/ parking assist monitor and intuitive parking assist system).
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch
wires.
* Turn the engine switch off before inspecting CAN bus wires for a ground short.
* After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not
operating.
* Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other
switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
HINT
* Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This
communication will cause the resistance value to change.
* Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring
due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may
help determine the cause of the malfunction.
PROCEDURE
1. RECONFIRM DTC OUTPUT
No comments:
Post a Comment