NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)
OK -- Continue to next step.
2. INSPECT YAW RATE AND ACCELERATION SENSOR (GND TERMINAL)
(a) Turn the engine switch off.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK -- Continue to next step.
3. RECONFIRM DTC
(a) Reconnect the yaw rate and acceleration sensor connector.
(b) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(c) Start the engine.
(d) Drive the vehicle at a speed of 3 km/h (2 mph) or more for at least 10 seconds.
(e) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
NOTICE:
Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
B -- REPLACE YAW RATE AND ACCELERATION SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction
No comments:
Post a Comment