NEXT -- Continue to next step.
9. RECHECK FOR DTC
(a) Recheck for DTCs and check if the same problem occurs again.
OK:
Malfunction disappears.
NG -- REPLACE RADIO RECEIVER ASSEMBLY See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Removal
OK -- END
From 08/2009
AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (w/o Navigation System): 01-D6,01-D7: No Master
01-D7 - Connection Check Error
DESCRIPTION
HINT
* *1: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
* *2: When 210 seconds have elapsed after disconnecting the power supply connector of the master component with the engine
switch on (IG) or (ACC), this DTC is stored.
NOTICE:
* Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check
for DTCs and troubleshoot according to the output DTCs.
* The radio receiver assembly is the master unit.
* Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
NOTICE:
Be sure to read Description before performing the following procedure.
PROCEDURE
1. CHECK RADIO RECEIVER ASSEMBLY POWER SOURCE CIRCUIT
HINT
Refer to Radio Receiver Power Source Circuit See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Testing and Inspection/Component Tests and General Diagnostics/Radio Receiver Power Source Circuit.
If the power source circuit is operating normally, proceed to the next step.
NEXT -- Continue to next step.
2. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE
(a) Enter diagnostic mode.
No comments:
Post a Comment