(a) Check that the yaw rate and acceleration sensor has been installed properly See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal.
OK:
The sensor is tightened to the specified torque.
The sensor is not installed in a tilted position.
NOTICE:
Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
NG -- INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY See: Brakes and Traction Control/Antilock
Brakes / Traction Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Installation
OK -- REPLACE YAW RATE AND ACCELERATION SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1421,C1423,C1424: Open or
Short in Master Cylinder Pressure Sensor
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.
No comments:
Post a Comment