2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) C CODE Page 456

(a) Check that the yaw rate and acceleration sensor has been installed properly See: Brakes and Traction Control/Antilock Brakes /

Traction Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal.

OK:

The sensor is tightened to the specified torque.

The sensor is not installed in a tilted position.

NOTICE:

Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /

Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.

HINT

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next

step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related

Diagnostic Procedures/Problem Symptoms Table.

NG -- INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY See: Brakes and Traction Control/Antilock

Brakes / Traction Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Installation

OK -- REPLACE YAW RATE AND ACCELERATION SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction

Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal

Up to 08/2009

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1421,C1423,C1424: Open or

Short in Master Cylinder Pressure Sensor

DESCRIPTION

The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.