(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for RH
for LH
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
Text in Illustration
NG -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
OK -- REPLACE FRONT SPEED SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel
Speed Sensor/Service and Repair/Front Speed Sensor/Removal
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1407,C1408: Open or Short in
Rear Speed Sensor RH Circuit
DESCRIPTION
The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for ABS control.
Speed sensor rotors have rows of alternating N and S magnetic poles, and their magnetic fields change when the rotors turn.
Each speed sensor detects that magnetic change and sends a pulse signal to the skid control ECU.
No comments:
Post a Comment