WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. INSPECT BACK DOOR LOCK ASSEMBLY (SECTOR SWITCH)
(a) Remove the back door lock assembly See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Lock/Service
and Repair/Removal.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE BACK DOOR LOCK ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Lock/Service and Repair/Removal
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - POWER BACK DOOR ECU)
(a) Disconnect the Y10 back door lock connector and P33 ECU connector.
No comments:
Post a Comment