WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
HINT
Check the condition of each related circuit connector before troubleshooting See: Accessories and Optional Equipment/Antitheft
and Alarm Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/Electronic Circuit Inspection
Procedure.
PROCEDURE
1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM AND BRAKE CONTROL SYSTEM)
(a) Check if the CAN communication system DTC is output See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/Diagnosis System.
(b) Start the engine.
(c) Drive the vehicle, accelerate to a speed of 3 km/h (2 mph) or more, and check if the speed sensor DTC (brake control system DTC) is
output See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes.
Result:
C -- REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (BRAKE CONTROL SYSTEM) See: Diagnostic Trouble Code
Descriptions/Vehicle Stability Control System
B -- REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (CAN COMMUNICATION SYSTEM) See: Diagnostic Trouble
Code Descriptions/CAN Communication System
A -- Continue to next step.
2. INSPECT BATTERY
(a) Check the battery voltage.
No comments:
Post a Comment