The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the center airbag sensor assembly and radio receiver assembly*1 or accessory meter assembly*2. Also
disconnect the connectors that link the instrument panel wire and No. 2 instrument panel wire.
*1: w/ Navigation System
*2: w/o Navigation System
(e) Check that the terminals of connectors are not damaged.
OK:
The terminals are not deformed or damaged.
NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
10. CHECK PASSENGER AIRBAG ON/OFF INDICATOR CIRCUIT (OPEN)
(a) Connect the connectors that link the instrument panel wire and No. 2 instrument panel wire.
(b) Using SST, connect terminals 23 (PAON) and 17 (P-AB) of connector B.
NOTICE:
Do not forcibly insert SST into the terminals of the connector when connecting the wire.
SST : 09843-18040
(c) w/ Navigation System:
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
(d) w/o Navigation System:
(1) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment