(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:
Text in Illustration
NG -- REPLACE TIRE PRESSURE WARNING ECU
OK -- REPLACE TIRE PRESSURE WARNING ANTENNA AND RECEIVER See: Instrument Panel, Gauges and Warning
Indicators/Tire Monitoring System/Tire Pressure Monitor Receiver / Transponder/Service and Repair/Removal
From 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: C2176/76: Receiver Error
C2176/76 - Receiver Error
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning
ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the ECU using Techstream and write them
down before removal.
* It is necessary to perform initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring
System/Testing and Inspection/Programming and Relearning/Initialization after registration See: Instrument Panel, Gauges
and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration of the
transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (ECU - RECEIVER)
(a) Disconnect the F53 ECU connector.
No comments:
Post a Comment