HINT
* *1: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
* *2: If the power connector is disconnected after the engine starts, this DTC is stored after 180 seconds.
* *3: If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the
device.
* *4: This DTC may be stored if the engine is started and the engine switch start again.
NOTICE:
* Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check
for DTCs and troubleshoot according to the output DTCs.
* The radio receiver assembly is the master unit.
* Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
NOTICE:
Be sure to read Description before performing the following procedure.
PROCEDURE
1. CHECK "RADIO RECEIVER COMMUNICATION ERROR" IN FLOW CHART
HINT
Refer to Radio Receiver Communication Error See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Testing and Inspection/Symptom Related Diagnostic Procedures/Audio and Visual System (w/o Navigation System)/Radio
Receiver Communication Error.
NEXT -- END
Up to 08/2009
AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (w/o Navigation System): 01-D5,01-D8,01-D9,01-DA,01-DB,01-DE: Absence of
No comments:
Post a Comment