2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 708

OK — Continue to next step.

29. CHECK FLOOR WIRE (SHORT TO GROUND)

(a) Turn the engine switch off.

(b) Disconnect the cable from the negative (-) battery terminal.

NOTICE:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG — REPLACE FLOOR WIRE

OK — Continue to next step.

30. CHECK SIDE AIRBAG SENSOR RH (FOR REAR SIDE)

(a) Connect the connectors to the rear airbag sensor RH and center airbag sensor assembly.

(b) Interchange the side airbag sensor LH (for rear side) with side airbag sensor RH (for rear side) and connect the connectors.

(c) Connect the cable to the negative (-) battery terminal.

(d) Turn the engine switch on (IG), and wait for at least 60 seconds.

(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes/DTC Check / Clear.

(f) Turn the engine switch off.

(g) Turn the engine switch on (IG), and wait for at least 60 seconds.

(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear.

from Blogger http://lexusworldzz.blogspot.com/2019/05/2010-lexus-truck-rx-350-awd-v6-35l-2gr_610.html