OK:
No scratches, oil, or foreign matter on the sensor tip.
NOTICE:
Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
NG -- CLEAN OR REPLACE REAR SPEED SENSOR
OK -- Continue to next step.
6. CHECK REAR SPEED SENSOR ROTOR
(a) Remove the rear speed sensor rotor See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle Hub/Removal.
(b) Check the speed sensor rotor.
OK:
No scratches, oil, or foreign matter on the rotor.
Result:
NOTICE:
Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If the rear speed sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
B -- CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - REAR SPEED SENSOR)
A -- CLEAN OR REPLACE REAR SPEED SENSOR ROTOR
7. CHECK HARNESS AND CONNECTOR (SKID CONTROL SENSOR WIRE)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(b) Disconnect the skid control sensor wire.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment