C -- GO TO DTC C2194/94
B -- GO TO DTC C2191/91
A -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
Up to 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: C2176/76: Receiver Error
C2176/76 - Receiver Error
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning
ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
- When replacing the tire pressure warning ECU, read the transmitter IDs stored in the ECU using Techstream and write them
down before removal.
- It is necessary to perform initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring
System/Testing and Inspection/Programming and Relearning/Initialization after registration See: Instrument Panel, Gauges
and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration of the
transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (ECU - RECEIVER)
(a) Disconnect the F53 ECU connector.
No comments:
Post a Comment