Systems/How To Proceed With Troubleshooting; 2) DTC inspection See: Steering and Suspension/Suspension/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes; and 3) Techstream inspection (Data List or Active Test) See:
Steering and Suspension/Suspension/Testing and Inspection/Scan Tool Testing and Procedures. If no malfunctions are found
in other areas, replace the suspension control ECU.
- If the suspension control ECU is replaced, the vehicle height offset calibration and registration of vehicle identification
information must be performed See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Testing and Inspection/Calibration and See: Steering and Suspension/Suspension/Suspension Control ( Automatic -
Electronic )/Testing and Inspection/Registration)
PROCEDURE
1. INSPECT AIR SUS RELAY
(a) Turn the engine switch off.
(b) Remove the AIR SUS relay from the engine room J/B.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE AIR SUS RELAY
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (AIR SUS RELAY - ECU AND BODY GROUND)
(a) Disconnect the A54 ECU connector.
(b) Remove the AIR SUS relay from the engine room J/B.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment