2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) C CODE Page 87

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

When replacing the brake actuator assembly, perform zero point calibration and store system information See: Brakes and

Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning.

PROCEDURE

1. RECONFIRM DTC

HINT

These codes are detected when a problem is determined in the brake actuator assembly.

The solenoid circuits are in the brake actuator assembly.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTCs are output

before replacing the brake actuator assembly.

(a) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes.

(b) Start the engine.

(c) Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.

(d) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and

Inspection/Reading and Clearing Diagnostic Trouble Codes.