(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for RH
for LH
Text in Illustration
Result:
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
C -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
B -- REPLACE REAR SPEED SENSOR (for AWD) See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Wheel Speed Sensor/Service and Repair/Rear Speed Sensor/Removal
A -- REPLACE REAR SPEED SENSOR (for 2WD) See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Wheel Speed Sensor/Service and Repair/Rear Speed Sensor/Removal
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1413,C1414: Front Speed
Sensor RH Output Malfunction
No comments:
Post a Comment