(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY See: Restraints and Safety Systems/Air Bag
Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal
Up to 08/2009
PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1626: Steering Angle Sensor Failure
C1626 - Steering Angle Sensor Failure
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates
an internal malfunction.
INSPECTION PROCEDURE
NOTICE:
- When "System initializing" is displayed on the multi-display after the battery terminal disconnected, correct the steering angle
neutral point See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Programming and Relearning/Parking Assist Monitor System/Initialization.
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance,
calibration of other systems as well as the parking assist monitor system may be needed See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Programming and Relearning/Parking
Assist Monitor System/Calibration.
PROCEDURE
1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
(a) Replace the spiral with sensor cable sub-assembly See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Steering Angle Sensor/Service and Repair/Removal.
NEXT -- Continue to next step.
No comments:
Post a Comment