NOTICE:
- When "System initializing" is displayed on the multi-display after the battery terminal disconnected, correct the steering angle
neutral point See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Programming and Relearning/Parking Assist Monitor System/Initialization.
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance,
calibration of other systems as well as the parking assist monitor system may be needed See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Programming and Relearning/Parking
Assist Monitor System/Calibration.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA)
(a) Disconnect the F55 connector from the parking assist ECU.
(b) Disconnect the Y14 connector from the rear television camera assembly.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK PARKING ASSIST ECU (CV-, CGND)
(a) Reconnect the F55 connector to the parking assist ECU.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment