(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK DTC OUTPUT (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH)
(a) Reconnect the 2H, 2D, T2, J7, K2, J1 and I2 connectors.
(b) Clear the DTC See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(c) After 10 seconds have elapsed, check if the trouble occurs again.
(d) Check for DTCs again.
No comments:
Post a Comment