2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) C CODE Page 316

(b) Remove the ABS NO. 1 fuse from the engine room relay block.

(c) Check if the fusible link is melted.

OK:

The fusible link is not melted.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPLACE FUSIBLE LINK BLOCK (ABS NO.1 FUSE)

OK -- Continue to next step.

3. INSPECT SKID CONTROL ECU (+BM TERMINAL)

(a) Install the fusible link block to the engine room relay block.

(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.

(c) Disconnect the skid control ECU connector.

(d) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (+BM CIRCUIT)

OK -- Continue to next step.

4. INSPECT SKID CONTROL ECU (GND2 TERMINAL)