for LH
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
Text in Illustration
NG -- REPLACE SKID CONTROL SENSOR WIRE
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - REAR SPEED SENSOR)
(a) Turn the engine switch off.
(b) Reconnect the skid control sensor wire (for 2WD).
(c) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(d) Disconnect the skid control ECU connector and the rear speed sensor connector.
(e) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment