HINT
It is necessary to perform the procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because
it cannot be identified by the output DTC.
INSPECTION PROCEDURE
NOTICE:
* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and note
them down before removal.
* It is necessary to perform initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring
System/Testing and Inspection/Programming and Relearning/Initialization after registration See: Instrument Panel, Gauges
and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration of the
transmitter IDs into the tire pressure warning ECU if the ECU and/or any of the valve and transmitters have been replaced.
PROCEDURE
1. CHECK TIRES
(a) Check that the tires are not flat, and have no indication of air pressure drop.
OK:
Tires are normal.
HINT
If a tire is damaged, the tire pressure warning valve and transmitter may also have been damaged at the same time.
NG -- REPLACE TIRE AND TIRE PRESSURE WARNING VALVE AND TRANSMITTER See: Instrument Panel, Gauges
and Warning Indicators/Tire Monitoring System/Tire Pressure Sensor/Service and Repair/Removal and Replacement/Removal
OK -- Continue to next step.
2. IDENTIFY TRANSMITTER CORRESPONDING TO DTC
(a) Set the tire pressure to the specified value See: Maintenance/Wheels and Tires/Testing and Inspection/Component Tests and General
Diagnostics.
(b) Turn the engine switch off.
(c) Connect Techstream to the DLC3.
(d) Turn the engine switch on (IG) and turn the tester on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(f) Display the "ID Tire Inflation Pressure" data for each wheel using the tester.
(g) Rapidly reduce the tire pressure for each wheel by at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.
(h) Check the DATA LIST.
No comments:
Post a Comment