Indicators/Testing and Inspection/Symptom Related Diagnostic Procedures/Problem Symptoms Table.
OK:
The speed value output from the speed sensor displayed on the Techstream is the similar speed as indicated on the
speedometer.
Result:
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
HINT
- The rear speed sensor rotor is incorporated into the rear axle hub and bearing assembly.
- If the rear speed sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear
speed sensor See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and
Repair/Rear Speed Sensor/Removal for 2WD).
- If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
C -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
B -- REPLACE REAR SPEED SENSOR AND REAR SPEED SENSOR ROTOR
A -- Continue to next step.
5. REPLACE REAR SPEED SENSOR
(a) Turn the engine switch off.
(b) Replace the rear speed sensor See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Removal.
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
NEXT -- Continue to next step.
6. RECONFIRM DTC
(a) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(b) Start the engine.
(c) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
(d) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
No comments:
Post a Comment