for DTCs and troubleshoot according to the output DTCs.
* The radio receiver assembly is the master unit.
* Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
NOTICE:
Be sure to read Description before performing the following procedure.
PROCEDURE
1. CHECK RADIO RECEIVER POWER SOURCE CIRCUIT
HINT
Refer to Radio Receiver Power Source Circuit See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Testing and Inspection/Component Tests and General Diagnostics/Radio Receiver Power Source Circuit.
If the power source circuit is operating normally, proceed to the next step.
NEXT -- Continue to next step.
2. INSPECT RADIO RECEIVER ASSEMBLY
(a) Disconnect the radio receiver assembly connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE RADIO RECEIVER ASSEMBLY See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Removal
OK -- Continue to next step.
3. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE
(a) Enter diagnostic mode.
No comments:
Post a Comment