Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (AVC-LAN COMMUNICATION LINE)
(a) Disconnect the multi-display assembly connector.
(b) Disconnect the display and navigation module display connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. REPLACE MULTI-DISPLAY ASSEMBLY
(a) Replace the multi-display assembly See: Accessories and Optional Equipment/Navigation System/Navigation Display/Service and
Repair/Removal and Replacement/Multi-Display/Removal.
(b) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for DVD).
(c) Recheck for DTCs and check if the same DTC is output again.
No comments:
Post a Comment