NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
10. INSPECT SKID CONTROL ECU (SENSOR INPUT)
(a) Reconnect the skid control ECU connector.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for RH
for LH
Text in Illustration
NG -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
OK -- Continue to next step.
11. PERFORM TEST MODE (SIGNAL CHECK)
(a) Turn the engine switch off.
(b) Perform the sensor check in the Test Mode procedure See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
OK:
All Test Mode DTCs are cleared.
NG -- REPLACE FRONT SPEED SENSOR
OK -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
12. REPLACE FRONT SPEED SENSOR
No comments:
Post a Comment