3. CHECK HARNESS AND CONNECTOR
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE REAR POWER WINDOW REGULATOR MOTOR RH
(a) Replace the rear power window regulator motor assembly RH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear
Door Window Regulator/Service and Repair/Removal.
NEXT -- Continue to next step.
5. CHECK DTC OUTPUT
(a) Clear the DTC See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(b) Check for DTCs.
OK:
DTC B2323 is not output.
NG -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
OK -- END (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH WAS DEFECTIVE)
From 08/2009
NETWORKING: LIN COMMUNICATION SYSTEM: B2323: Rear Door RH ECU Communication Stop
B2323 - Rear Door RH ECU Communication Stop
DESCRIPTION
This DTC is stored when LIN communication between the rear power window regulator motor assembly RH and main body ECU (multiplex
network body ECU) stops for more than 10 seconds.
No comments:
Post a Comment