OK -- END
Safety Connect System
CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C0,B15C1: Short in GPS Antenna
B15C0 - Short in GPS Antenna
B15C1 - Open in GPS Antenna
DESCRIPTION
This DTC is set when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna circuit. The DCM (Telematics
Transceiver) receives 1574.42 - 1576.42 MHz radio frequency signal from satellites through the telephone and GPS antenna assembly. The cable is
a 50 Ohms coaxial cable.
HINT
Refer to "PARTS LOCATION" for the installation location of telephone and GPS antenna cord See: Accessories and Optional
Equipment/Emergency Contact Module/Locations/Safety Connect System.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "HEALTH CHECK" and check for current DTCs See: Accessories and Optional Equipment/Emergency Contact
Module/Testing and Inspection/Initial Inspection and Diagnostic Overview/Safety Connect System/Health Check.
Result:
B -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
A -- Continue to next step.
2. INSPECT TELEPHONE AND GPS ANTENNA CORDS (NO. 2 INSTRUMENT PANEL WIRE)
(a) Disconnect the No. 2 instrument panel wire (antenna cord sub-assembly) connector from the DCM (Telematics Transceiver).
No comments:
Post a Comment