(a) Turn the engine switch off.
(b) Perform the sensor check in the Test Mode procedure See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
OK:
All Test Mode DTCs are cleared.
NG -- CHECK REAR SPEED SENSOR INSTALLATION
OK -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
6. CHECK REAR SPEED SENSOR INSTALLATION
(a) Turn the engine switch off.
(b) Check the speed sensor installation (for 2WD).
OK:
There is no clearance between the sensor and the rear axle carrier.
(c) Check the speed sensor installation (for AWD).
OK:
There is no clearance between the sensor and the rear axle carrier.
The installation bolt is tightened properly.
Torque
8.0 N*m (82 kgf*cm, 71 in.*lbf)
Result:
D -- INSTALL REAR SPEED SENSOR CORRECTLY (for AWD)
C -- INSTALL REAR SPEED SENSOR CORRECTLY (for 2WD) See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Wheel Speed Sensor/Service and Repair/Rear Speed Sensor/Installation
B -- CHECK HARNESS AND CONNECTOR (SKID CONTROL SENSOR WIRE)
A -- Continue to next step.
No comments:
Post a Comment