2. CHECK FOR DTC
(a) Check for DTCs See: Steering and Suspension/Steering/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
NOTICE:
If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point
calibration have been performed, confirm the procedure again, and perform the calibration and initialization 3 times.
HINT
Replace the power steering ECU if DTC C1515 or C1525 is still output after performing rotation angle sensor value initialization
and torque sensor zero point calibration 3 times.
B -- END
A -- Continue to next step.
3. REPLACE POWER STEERING ECU
(a) Replace the power steering ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules -
Steering/Steering Control Module/Service and Repair/Removal.
NEXT -- Continue to next step.
4. INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
(a) Initialize the rotation angle sensor value and calibrate the torque sensor zero point See: Steering and Suspension/Steering/Testing
and Inspection/Programming and Relearning.
NEXT -- Continue to next step.
5. CHECK FOR DTC
(a) Check for DTCs See: Steering and Suspension/Steering/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
NOTICE:
If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point
calibration have been performed, confirm the procedure again, and perform the calibration and initialization 3 times.
HINT
Replace the steering column assembly if DTC C1515 or C1525 is still output after performing rotation angle sensor value
initialization and torque sensor zero point calibration 3 times.
B -- END
A -- REPLACE STEERING COLUMN ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Removal
Up to 08/2009
POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: C1516,C1526: Torque Sensor Zero Point Adjustment Incomplete
No comments:
Post a Comment