(c) Replace the seat position airbag sensor with a known good part See: Restraints and Safety Systems/Air Bag Systems/Seat Position
Sensor/Service and Repair/Removal.
HINT
Perform the following inspection using known good parts from another vehicle if possible.
NEXT -- Continue to next step.
8. CHECK CENTER AIRBAG SENSOR ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal.
(b) Turn the engine switch on (IG), and wait for at least 60 seconds.
(c) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(d) Turn the engine switch off.
(e) Turn the engine switch on (IG), and wait for at least 60 seconds.
(f) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1653/35 is not output.
Text in Illustration
HINT
Codes other than DTC B1653/35 may be output at this time, but they are not related to this check.
NG -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and
Safety Systems/Air Bag Control Module/Service and Repair/Removal
OK -- END
1. CHECK NO. 2 FLOOR WIRE (OPEN)
(a) Disconnect the No. 2 floor wire from the front seat inner belt assembly LH.
HINT
SST has already been inserted into connector B.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment