2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) C CODE Page 342

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FRONT SPEED SENSOR INSTALLATION

(a) Check the speed sensor installation.

OK:

There is no clearance between the sensor and the front steering knuckle.

The installation bolt is tightened properly.

Torque

8.0 N*m (82 kgf*cm, 71 in.*lbf)

NG -- INSTALL FRONT SPEED SENSOR CORRECTLY

OK -- Continue to next step.

2. CHECK FRONT SPEED SENSOR TIP

(a) Remove the front speed sensor See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed

Sensor/Service and Repair/Front Speed Sensor/Removal.

(b) Check the speed sensor tip.

OK:

No scratches, oil, or foreign matter on the sensor tip.

NOTICE:

Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction

Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.

NG -- CLEAN OR REPLACE FRONT SPEED SENSOR

OK -- Continue to next step.

3. CHECK FRONT SPEED SENSOR ROTOR

(a) Remove the front speed sensor rotor See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft

Assembly/Service and Repair/Front Drive Shaft Assembly/Removal.

(b) Check the speed sensor rotor.